| [Thermostat] | 溫控器 |
Bend L-feet thermostar
The maximum working current: 10A; 15A (resistive load)
Operating temperature: 45-200 degrees C (special requirements can be settled through negotiation)
Action deviation: + 1 + 2 + 3 + 5 degree C
Product life: not less than 30000 times (resistive load)
Contact resistance: not greater than 50m.
Dielectric strength: AC50HZ2000V for 1min without the phenomenon of breakdown flashover
Insulation resistance: greater than 100M.
Heat resistance: the maximum use temperature of Tn= action temperature of To+35 DEG C
Details:
The characteristics of:
The thermostat is a small temperature controller, its working temperature is fixed, no need to adjust, reliable action, simply, no arcing, long service life, less radio interference. Automatic reset, and manual reset.
The working principle of:
The thermostat is a temperature relay device temperature sensor, a dish shaped elementadopts a double metal sheet made of as a temperature sensing element, deformation principleat different temperatures by using a disk element, through the mechanism, make contacts act quickly, to connect or disconnect the circuit purpose.
The adaptation range:
This product can be used for household appliances for temperature control and overheat protection, and can be used for disinfection cabinet, electric heating thermos, Coffee pot,electron watt brace, microwave oven, hair dryer, electric heaters, dryers and other appliances.
The product structure:
Orders and instructions for use:
The user must be according to the characteristics of their products, accurate determination ofthe actual temperature thermostat and a fuse body parts in thermal stability after, and through the matching test to determine the temperature controller and the temperature fuse action,and then put forward the action ordering temperature value.
When ordering, the user must specify the set temperature controller and a fuse body type,and specify the installation hole dimensions and terminal temperature controller size and shape.
The special requirements of users put forward in a really need, including the temperature andshape, the factory can be resolved through consultation.
When in use, the temperature controller and the fuse of whole sealing type should as far as possible so that the metal shell is immediately accused product installation position. The installation can not be the metal casing collapse or deform. In order to avoid operating temperature variation or affect other properties. Manual reset operation manual reset type temperature controller must be below the nominal operating temperature of 15 degrees, the implementation should be less than 30N, so as not to damage the reset mechanism.